California residents - This item is not CARB Approved - We can not ship this item to California.  If you order this item to ship to a California address we will cancel and refund your order.

THIS KIT IS SOLD FOR OFF ROAD - RACING PURPOSES ONLY - DO NOT PURCHASE AND INSTALL THIS IF INSTALLATION WILL VIOLATE ANY LOCAL OR FEDERAL LAWS - ADAPTED PERFORMANCE ASSUMES NO LIABILITY FOR INSTALLATION OR USE OF THIS ITEM

This is a new release from our Basic EGR Delete kit's.   We call our kits Basic because they are exactly what an egr kit should be, BASIC.

Click HERE for our full EGR delete kit

This is our 2 piece secondary EGR Delete kit.  This kit will allow you to remove the egr pipe from the head to the intake manifold on all mazdaspeed 3's & 6's and all turbo mazda cx-7's.

The plate:  We start with precision cut .093 thick 5052 aluminum.  The plates are surface ground for flatness to ensure a proper seal.  The plate is engraved with our logo and is dipped in an anti corrosion coating to prevent oxidizing.   Install using either a factory gasket or a thin layer of any silicone sealer rated for 500+ degrees (black, red or orange)

The plug: We sourced the finest plug to go with our kit that we could find.  The plug has a flat sealing shoulder that by itself can seal to the manifold, but we still suggest using teflon tape to act as an additional sealant.   The plug uses a hex head so no need to dig for an allen key with this one.